These popular TECHOMAN ATS-20+ receivers are a quality full-band radio receiver with a 0.96" OLED display and supporting auto-hold setting function after power failure. Equipped with audio output, it supports 3.5mm earphones. Also, it supports 4 ohm speaker 2W output. With 22 commercial and ham radio bands pre-configured, you can use it easily.
Functions and Features:
- 0.96" OLED display, you can see the FM band, AGC on/off, MONO selections
- Supported Modes: FM, AM (MW and SW) and SSB (LSB and USB)
- Supports auto-hold setting function after power failure
- Internal rechargeable 3.6V 800mAh polymer lithium battery
- USB recharging
- Internal speaker included
- Equipped with audio output to support 3.5mm earphones
- Also supports 8 ohm speaker 1.5W output
- Antenna connector is BNC type
- With 22 commercial and ham radio bands
- Audio bandwidth filter 0.5, 1, 1.2, 2.2, 3 and 4Khz
- BFO Control
- Frequency step switch (1, 5 and 10KHz)
Frequency Bands:
- Longwave (LW): 100 – 510 kHz
- Medium Wave (MW): 520 – 1720 kHz
- Shortwave (SW): 1.720MHz - 30.000 MHz
- 160 meters
- 80 meters
- 40 meters
- 30 meters
- 20 meters
- 17 meters
- 15 meters
- 12 meters
- CB band (11 meters)
- 10 meters
- FM Broadcast Band: 76.00 – 108.00 MHz
Package Includes:
1x TECHOMAN ATS-20+ DSP Receiver
1x Telescopic Antenna
1x USB Charging Cable
WARRANTY NOTICE: Do not attempt to connect a USB cable to the USB Download Socket located on the back of the ATS-20+ receiver. Using the Type C USB Charging Socket to charge the internal batteries is fine, however the USB Download Socket connection requires a special programming cable and extended knowledge on firmware upgrades - if doing this incorrectly, damage to the radio will very likely occur and void the warranty. We do not recommend trying to upgrade the firmware from the standard factory firmware as doing this could very likely internally damage or "brick" the radio and make it unusable. To protect the radios we have placed a Warranty Void label over the USB Download Socket as any attempts to connect to the USB Download Socket will void the warranty. DO NOT REMOVE THIS WARRANTY LABEL.